44
LOAD CARRYING MECHANISM (cont’d)
OPTIONAL AUTO LIFT
When equipped with the auto lift function, the load carrying device will
automatically keep the height of the load carry device three inches off
the ground.
During operation of the unit, if the load carrying device is lowered below
three inches, the forks will automatically raise to three inches when the
operator stops pushing the lower button.
When loading or unloading pallets from the unit it is necessary for the
operator to hold down one of the lower buttons until the pallet is fully
engaged or exited.
NOTE:
If the operator presses and holds the lower button and then turns off
the ignition switch, the load carrying device will remain lowered to the
oor. When the ignition switch is turned on, the load carrying device will
remain lowered to the oor until the operator lifts or lowers for the rst
time.
OPERATING CONTROLS AND FUNCTIONS
To Next Page
Loading...
