Unify CP200 - Enhanced Phone Functions

70
Enhanced phone functions
Incoming calls
Deflecting a call
Using call deflection
Prerequisite: An incoming call is displayed or signaled. "Deflect" must be al-
lowed.
Select and confirm the option shown.
If a destination phone number is stored ( page 70), you can select and confirm
it. The call is deflected.
or If you did not set a phone number when programming call deflection, you are
now prompted to enter a destination phone number for call deflection.
j Enter and confirm the destination phone number. The call is deflected.
Permitting call deflection
z You can also configure this setting via the WEB interface  page 160.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Confirm the option shown.
Select and confirm the option shown.
j Enter the phone number to which the subscriber is to be deflected and confirm.
Deflect? m
089008844 l
ñ
"Deflect" must be authorized by the administrator.
User
Configuration
Incoming calls
Deflecting?
Allow deflection = No f
Yes l
Default destination = f
Entering a destination phone number is not mandatory when call deflec-
tion is active. If you want to deflect an incoming call, you are prompted to
enter a destination phone number if there is none stored.