Unify CP200 - CTI Calls

86
CTI calls
Beep on auto-answer
When you dial a number with a CTI application (e.g. Outlook) and auto-answer
is activated, the phone switches automatically to speakerphone mode. If auto-
answer is deactivated, the phone first rings and you have to press the loud
-
speaker key or lift the handset in order to set up the call. This setting also defines
whether or not incoming calls are automatically accepted. If the function is ac
-
tive, an alert beep sounds when an incoming call is automatically accepted.
Information on the operation of the configured CTI application can be found in
the corresponding operating instructions.
z You can also configure this setting via the WEB interface  page 160.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
ñ
The CTI option was programmed by your administrator.
User
Configuration
Incoming calls?
CTI calls? f
AutoAnswer = No f
Yes l
AutoAnswer beep = No
Yes l
Save & exit l