Unify CP200 - Page 81

81
Connecting parties
Select and confirm the option shown. The other two parties are now connected
to one another. You can now hang up or dial another number for instance.
or Connecting by hanging up
] or É
Replace the handset or, if you are in speakerphone mode, press the loudspeak-
er key. The other two parties are now connected to one another.
Allowing call waiting
z You can also configure this setting via the WEB interface  page 160.
@ Press the key shown.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Assuming Allow call waiting is activated, you can toggle a configured key to
switch call waiting on/off (
 page 68).
Complete Xfer
ñ
Connecting by hanging up is activated (ask your administrator) and
"Switch assignment" must be set to "Yes" (
 page 82).
If the call waiting (second call) function is deactivated, a caller hears the
busy signal if you are already conducting a call.
ñ
The second call option was programmed by your administrator.
User
Configuration
Incoming calls?
Handling? f
Allow call waiting = No f
Yes l
Save & exit l