Additional System Settings
3) Under Common, click “Network” in the menu on the Advanced Configuration page
Figure 36: The Network Page
4) The following parameters can be set (some of these parameters can also be set in the setup
wizard):
• Require network connection – Controls if the module needs a connection to the network to
start up. This can be useful if you want configure the module before connecting it to a net-
work.
• DHCP – Controls whether static or dynamic IP address shall be assigned to this Elise
module. If DHCP is enabled, only the host name below is applicable.
• IP address – Sets the IP address for the module
• Default gateway – Sets the IP address to a Gateway on the LAN
• Subnet mask – sets the network mask that is to be used. If this parameter is set to 0.0.0.0
it means that the Gateway never will be used.
• Host name
• Domain name – Sets the desired domain name for the module
• DNS Server – Sets the IP address to a DNS if one exists. If no DNS Server is present on
the network, set this parameter to 0.0.0.0.
• WINS Server – sets the IP address to a Primary WINS Server if one exists.
• If no WINS Server is present on the network, set this parameter to 0.0.0.0.
5) Click “Activate”.
A31003-M2000-M105-01-76A9, 29/06/2020
Wireless Service Gateway WSG, Administrator Documentation 67
To Next Page
Loading...
Need help?
General