Unify OpenScape WLAN Phone WL4 - Setting the License Number; Reboot

Additional System Settings
Setting the License Number
Setting the License Number
The license number is normally set in the setup wizard but it can also be set on the Advanced
Configuration page.
1) Click “Configuration” on the start page.
2) Select Other Settings > Advanced Configuration on the Configuration page.
3) Under Common, click “License” in the menu on the Advanced Configuration page
4) Enter the license number and click “Activate”.
Reboot
The module can be rebooted on the Advanced Configuration page.
1) Click “Configuration” on the start page.
2) Select Other Settings > Advanced Configuration on the Configuration page.
3) Under Common, click “Reboot” in the menu on the Advanced Configuration page
4) Click the “Reboot” button.
If the Reboot page is reloaded, this will trigger another reboot.
A31003-M2000-M105-01-76A9, 29/06/2020
68 Wireless Service Gateway WSG, Administrator Documentation