Unify OpenStage 30 T - Configuring Redial Keys

56 Programming the function keys
Configuring repdial keys
You can also program internal and external station numbers on the second level.
The LED function is not available for internal station numbers on the second lev
-
el. To program the second level, you must program a "Shift" key  Page 52.
See also  Page 14.
N Open the Program/Service menu  Page 17.
Select and confirm the option shown.
S Press the key shown.
Confirm.
if nec.
Select and confirm the option shown.
Confirm.
Confirm.
j Enter the station number.
If you make a mistake:
Select and confirm the option shown. This deletes all entered digits.
Confirm.
or
Select and confirm the option shown.
Deleting function key programming
N Open the Program/Service menu  Page 17.
Select and confirm the option shown.
S Press the key shown.
Select and confirm the option shown.
*91=Key assignment
Change key
+=Next layer
Destinations
Repdial key
previous
Exit
Another key
You dial the saved number by pressing the key  Page 23.
You can also save a number during a call.
*91=Key assignment
Clear key