Unify OpenStage 30 T - Changing Phone Number and Resetting Services

68 More functions/services
Changing a number (after exchanging/
moving/relocating a phone)
When configured (consult your service personnel), you can move your number
to any other phone.

Your phone to date is then assigned the old number of your new phone; the num-
ber including phone settings (e. g. programmed keys) are exchanged.
Prerequisite: Your old and new telephone are the first telephones at each con-
nection. The telephones are in idle state.
The following procedure is carried out on the new phone.
N Press the key shown.
Select and confirm the option shown.
j Enter own station number.
j Enter code (telephone lock)  Page 63.
(Not necessary if you have not set a code.)
Confirm.
Resetting services and functions
(system-wide cancellation for a telephone)
A general reset procedure is available for initiated functions. The following func-
tions are deleted, if enabled:
• Forwarding on
• Advisory msg. on
• Ringing group on
• Hunt group off
• Suppress call ID
• Call waiting tone off
• Do not disturb on
• Ringer cutoff on
• Received messages:
• View callbacks
N Press the key shown.
Select and confirm the option shown
1
.
Relocate?
Complete relocate?
If you change numbers of different system phones, programmed keys are
replaced with the default assignment.

You can however connect your phone to a different port and then carry out
the procedure.
#0=Reset services?
1. ”Differing display view in a HiPath 4000 environment”  Seite 88