Making calls in the team/executive/secretary configuration 75
Trunk keys
The programmable keys on multi-line phones function as line keys. Every sen-
sor key programmed as a "Trunk key" (key label: Transfer Trk) corresponds to
a trunk with the result that you can configure up to
8 trunks in OpenStage 30 T .
As a team member, you can independently program the following functions on
keys
Page 52:
• Direct station select
• Join/leave group
(not available on executive phone in an executive/secretary team)
• Ring Transfer: On/Off
(only in an executive/secretary team)
You can also program a sensor key with the function "Forward Line" (call for-
warding) for each line.
LED displays on trunk keys
Answering calls with the trunk keys
Prerequisite: Your telephone rings or the trunk key flashes quickly.
if nec. T Press the trunk key that is flashing quickly.
(not necessary if "Prime Line" is active).
^ Lift the handset.
or On-hook dialing: Speakerphone mode.
Dialing with trunk keys
if nec. S Press the free trunk key you wish to use to establish the connection
(not necessary if "Prime Line" is active).
j Dial the phone number.
^ If the party does not answer: Lift the handset.
or On-hook dialing: Speakerphone mode.
LED Explanation
S
Off
– The line is in idle mode.
T
Flashing
1
1 In this manual, flashing keys are identified by this icon, regardless of the flashing interval. The
flashing interval represents different statuses, which are described in detail in the corresponding
sections of the manual.
– Incoming call on the line.
– Hold reminder is activated.
– The line is on "Hold".
R
On
– The line is busy.
To Next Page
Loading...
Need help?
General