70 More functions/services
Using system functions from outside
DISA (direct inward system access)
If configured (contact your service personnel), you can use an external phone
like an internal station
to set up an outgoing external connection via the system.
You can also activate or deactivate the following system functions:
• Reset services and functions,
code #0
Page 68
• Call forwarding, code
*
1/#1 Page 26
• Lock and unlock phone,
code
*
66/#66 Page 62
• Save your PIN,
code
*
93 Page 63
• Send a message,
code
*
68/#68 Page 65
• Leave an advisory message,
code
*
69/#69 Page 66
• Ringing group, code
*
81/#81 Page 81
• Group call, code
*
85/#85 Page 81
• Caller ID suppression,
code
*
86/#86 Page 60
• Camp-on tone, code
*
87/#87 Page 44
• Open door, code
*
61 Page 32
• Release door opener, code
*
89/#89 Page 33
• Control relays, code
*
90/#90 Page 73
• Do not disturb, code
*
97/#97 Page 59
• Ringer cutoff, code
*
98/#98 Page 59
• Dial using speed dial, code
*
7 Page 39
• Associated service, code
*
83 Page 69
Prerequisite: Your phone supports tone dialing (DTMF) or you can switch your
phone to tone dialing. The phone is not connected to the system.
j Establish a connection to the system. Enter the station number (contact your
service personnel).
j Wait for the continuous tone (if necessary, switch phone to tone dialing) and en-
ter the internal number assigned to you and the corresponding PIN.
( Enter the code (only required if programmed in the system).
j Wait for the dial tone and enter the code for example,
*
97 for Do not disturb on.
If necessary, make further entries; refer also to the user guide for dial pulse/
DTMF phones.
or
j Dial the external number.
You can only perform one function/establish one outgoing connection at a
time.
The connection is cleared as soon as the function is successfully activat-
ed.
In the case of an external call, the connection is cleared as soon as one of
the call partners hangs up.
To Next Page
Loading...
Need help?
General