- 43 -
7. INSTALATION INSTRUCTIONS
7.1 General
All parts and accessories are packed and shipped with appropriate measure to ensure that
everything is protected during transportation.
The installation team must be familiar with the installation requirements, to exercise due care
in handling and to prevent damage to the equipment.
The following instructions are in addition to and conform to any state and municipal
regulations which may apply. These instructions do not cover all features concerning HVAC
installation or methods of procedure.
The installation must be performed in accordance with manufacturer's specifications using
only approved tubing, original cables and original accessories.
7.2 Standard Accessories
Fig. 7-1
7.3 Electrical Requirements
• The electrical installation must be performed only by qualified personnel, in
accordance with local regulations.
• The air conditioner must be directly connected to an appropriate power supply.
• Use only type "C" or type "G" fuses, as specified in the appropriate data table.
• Use only a single length power cable, without extensions.
NOTE: The compressor is equipped with oil heating element. Main circuit breaker and
power supply must therefore always be ON.
If disconnected, make sure that power supply was ON at least 6 hours before starting
the unit.
To Next Page
Loading...