© 2023 All rights reserved, Unitree Robotics 12
After the robot is placed according to the requirements, start it up according to the following steps:
Firstly, press the Go2 power switch button briefly for 1 time, then press the power switch button for 2
seconds or more, then Go2 can be started up During the startup process, the Go2 head indicator light
flashes in green. And wait for 2 minutes, the head indicator light is in green permenantly, and the body
is parallel to the ground, then the robot is started up.
⚫ If the start-up fails, please check the body placement carefully.
⚫ The Go2 may fail to start up if the legs are stretched outwards or if the legs are pressed inwards.
⚫ Hand may be pinched at the motion joints, please be careful!
Before switching off, please make sure that the robot is standing on a flat surface, and make sure
that the robot is in a static standing state (the robot body position is in the initial state on the power-
up, the body is horizontal, and the state is in the static standing state.
1) Operate the robot into the prone state;
2) After the robot enters the prone state, short press the power button then long press the power button
for 2 seconds to switch off the robot.
After switching off the robot, please follow the body placement requirements and position Go2's
big and small legs and hip joints to prepare for the next start-up. If you do not use Go2 for a long time,
please remove the battery pack and follow the packing steps to put Go2 into the dedicated luggage.
⚫ Please make sure that the robot turned off in a damping state, otherwise the robot will fall heavily on the ground
after it is turn down and powered off, which may cause damage to the robot body and certain potential hidden
dangers! If the power on fails, please check if the robot body is placed correctly.
Long press+short press for 2 seconds
To Next Page
Loading...
