© 2023 All rights reserved, Unitree Robotics 21
Cleaning: After using Go2, if there are stains on the surface, please clean the surface of the body
in time. Before wiping the body, please switch off the power, use a dry and clean soft cloth to wipe the
body, pay special attention to the camera and radar whether to wipe clean.
Storage: Go2 is not dustproof or waterproof, it should be stored in a dry and cool room, avoiding
sunlight and rain, so as not to shorten the service life of the parts due to water ingress and rust
corrosion.
Routine inspections before and after use can significantly improve product reliability,
reduce potential hazards and extend service life.
Uncharged Checklist
1. Whether the appearance of the body is clean, no signs of damage or deformation.
2. Whether the lens on the camera surface has foreign matters.
3. Whether there is no dust around the head LIDAR.
1. Visually and touch to check whether the body, joints, connections, and foot end parts
are in good condition.
2. Ensure that the screws of all connecting parts are locked, especially the screws of
joint connectors and battery locking knobs.
3. Whether the inlet and outlet of heat sink are blocked by foreign matters.
Check whether there is obvious foot pad damage.
1. Check the battery pack interface of the body for foreign matters and deformation.
2. Whether the battery pack is installed reliably to ensure that it will not loosen during
operation.
3. The battery pack with obvious damage is forbidden to be used.
Check whether each key of the remote control is lagged.
1. Confirm whether the basic operation function of the rocker is normal.
2. Confirm whether the current power is sufficient.
Confirm whether the current power is sufficient.
Battery pack maintenance
1) Never charge the battery pack in an environment where the temperature is too high or too low
2) Never store the battery pack at room temperatures above 40°C.
3) Do not overcharge the battery pack as this will cause damage to the cells.
4) If you do not use the battery for a longer period of time, please check the remaining battery
power regularly, if the power is less than 30%, please charge the battery to 70% before continuing to
store. So as not to over-discharge the battery and damage the battery.
To Next Page
Loading...
