Uponor Smatrix Base Thermostat Prog.+RH T-148
The thermostat shows the ambient, set temperature
or relative humidity, and time on the display. Settings
are adjusted using the +/- buttons on the front. Other
programmable settings are scheduling and individual
ECO mode (on a room by room basis) etc.
Uponor recommends only using this thermostat in
systems without a timer. Because scheduling and
priority issues might occur.
Main characteristics:
• Backlit display, dims after 10 seconds of inactivity.
• Displays Celsius or Fahrenheit.
• Calibration of displayed room temperature.
• Heating/cooling demand indication on display.
• Displays software version during power up
sequence.
• Setup wizard to set time and date when installed for
the first time or after a factory reset.
• 12/24h clock for scheduling.
• Internal memory to save time and date settings
during short power outages.
• Setpoint range is 5 – 35 °C (maximum and
minimum setting may be limited by other system
settings).
• Room temperature regulation with use of optional
external temperature sensors.
• Displays optional temperature sensor values
if sensors are connected and relevant room
temperature regulation is activated.
• Programmable to switch between Comfort and ECO
modes with adjustable ECO setback value in the
room.
• Cannot be overridden by other thermostats or
timers, when it is set to a program.
• Relative humidity limit indicated in display.
• Scheduling, pre-programmed and customizable
schedules.
• Lower indoor temperature on a room by room basis
with ECO mode.
Components of the thermostat:
The illustration below shows the thermostat and its
components.
To Next Page
Loading...
Need help?
General
