THERMOSTATS T-146 AND T-148
5.1 Press and hold both - and + buttons on the
thermostat until the text CnF (configure) and a
communication icon is displayed.
The selected channel LED in the controller turns
fixed green and the registration is complete.
THERMOSTAT T-149
5.1 Press and hold both and buttons on the
thermostat until the communication icon is
displayed.
The selected channel LED in the controller turns
fixed green and the registration is complete.
6. Repeat steps 2 through 5 until all used room
thermostats are registered.
7. Press and hold the OK button on the controller
until the green LEDs turn off to end registration and
return to run mode.
To unregister already registered thermostats, see section
10.6 Unregister channels in controller.
6.12 Register system devices
In addition to room thermostats, the controller can also
be connected to system devices.
Available system devices:
• Touch screen interface (Base PRO only), see section
8 Install Uponor Smatrix Base PRO interface for
installation procedure
• Timer, see section 7 Install Uponor Smatrix Base
timer for installation procedure
• Public thermostat with various functions
The illustration below shows how to register system
devices to the controller.
To Next Page
Loading...
Need help?
General
