Uponor Smatrix Base PRO Room Sensor+RH Style
T-141
The thermostat is designed to be as small as possible,
and still able to control the room temperature.
Main characteristics:
• Operative sensor for increased comfort.
• Adjust setpoint temperature via the Base PRO
interface I-147.
• Setpoint range is 5 – 35 °C (maximum and
minimum setting may be limited by other system
settings).
• Relative humidity limit indicated in display via the
Base PRO interface I-147.
Components of the thermostat:
The illustration below shows the thermostat and its
components.
Uponor Smatrix Base Timer I-143 (Base only)
The timer enables control of the system with
scheduling, Comfort/ECO settings, and Holiday mode
etc. Settings are adjusted using the +/- buttons on the
front.
The timer only shows time, date and current scheduling
program.
Main characteristics:
• Backlit display, dims after 10 seconds of inactivity.
• Timer symbol on the front to differentiate it from
thermostats.
• Displays Celsius or Fahrenheit in the settings.
• Comfort/ECO and heating/cooling mode indication
on display.
• Displays software version during power up
sequence.
• Setup wizard to set time and date when installed for
the first time or after a factory reset.
• 12/24h clock for scheduling.
• Internal supercapacitor to save time and date
settings during short power outages.
• ECO mode setback for analogue thermostats. Digital
thermostats use their own setback temperatures.
Thermostat T-148 required to set its program to Off.
• Scheduling, pre-programmed and customizable
schedules.
• Disable/enable holiday mode.
• Enable autobalancing in the system.
Components of the timer:
The illustration below shows the timer and its
components.
To Next Page
Loading...
Need help?
General
