Page 2-1MX15/19
Section 2
O
PERATION AND
S
PECIFICATIONS
WARNING
All personnel shall carefully read, understand and follow all safety rules, operating
instructions, and the Scaffold Industry Association’s
MANUAL OF
RESPONSIBILITIES of ANSI A92.6-1999
before performing maintenance on or
operating any UpRight Aerial Work Platform.
Safety Rules
NEVER operate the machine without first surveying the work area for surface hazards such as holes, drop-offs,
bumps, and debris.
NEVER operate the machine if all guardrails are not properly in place and secured with all fasteners properly
torqued.
SECURE chain across entrance after mounting platform.
NEVER use ladders or scaffolding on the platform.
NEVER attach overhanging loads or increase platform size.
LOOK up, down, and around for overhead obstructions and electrical conductors.
DISTRIBUTE all loads evenly on the platform. See the back cover for maximum platform load.
NEVER use damaged equipment. (Contact UpRight for instructions. See toll-free phone number on back cover.)
NEVER change operating or safety systems.
INSPECT the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged control cable, loose
wire connections, and wheel bolts.
NEVER climb down elevating assembly with the platform elevated.
NEVER perform service on machine while platform is elevated without blocking elevating assembly.
NEVER recharge battery near sparks or open flame; batteries that are being charged emit highly explosive hydro-
gen gas.
AFTER USE secure the work platform against unauthorized use by turning key switch off and removing key.
NEVER replace any component or part with anything other than original UpRight replacement parts without the
manufacturer’s consent.
NEVER elevate the platform or
drive the machine while elevated
unless the machine is on firm
level surface.
NEVER sit, stand, or climb on
guardrail or midrail.
NEVER operate the machine
within ten feet of power lines.
THIS MACHINE IS NOT
INSULATED.
MX15/19
Serial No. 14000 to Current
To Next Page
Loading...
Need help?
General
