US Robotics COURIER - Canadian Modem User Information

-
-
-
-
-
-
-
-
-
COURIER HIGH SPEED MODEMS
FOR CANADIAN MODEM USERS
The Canadian Department of Communications (DOC) label
identifies certified
equipment. This certification means that the
equipment meets certain telecommunications network
protective, operational, and safety requirements. The
department does not guarantee the equipment will operate to a
user's satisfaction.
Before installing this
equipment, make sure you are permitted to
connect it to
the facilities of the local telecommunications
company. You must also install the equipment using an
acceptable method of connection. In some cases, you may also
extend the company's inside wiring for single line individual
service by means of a certified connector assembly (telephone
extension cord). You should be aware, however, that
compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified
equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any
repairs or alterations made by a user to this equipment, or
equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
For your own protection, make sure that the electrical ground
connections of the power utility, telephone lines, and internal
metallic water pipe system, if present, are connected together.
This
precaution may be particularly important in rural areas.
CAUTION: Do not attempt to make such connections yourself;
contact
the appropriate electric inspection authority or
electrician.
Courier High Speed Modems Load Number: 5
The Load Number (LN) assigned to each terminal device
denotes the percentage of the total load to be connected to the
telephone loop used by the device, without overloading. The
termination on a loop may consist of any combination of devices,
subject
only to the requirement that the total of the Load
Numbers of all the devices not exceed 100.
Regulatory Information xiii