US Robotics COURIER - Page 159

COURIER HIGH SPEED MODEMS
pressing the <Enter> key. To assign a password that allows
viewing privileges only, use the following command format.
AT%PO=[password] <Enter>
To assign a password that allows viewing and configuration
privileges, use this command format.
AT%P1 =[password] <Enter>
NOTE: If you enable remote access by pressing the voice/ data
switch while powering on the modem, previously set passwords
will be erased.
Login Attempts
The Register S41 setting designates the number of allowable
login attempts by the remote user, thus enabling or disabling
remote access. If the number of allowable login attempts is set to
0, remote access is disabled. If the number of allowable login
attempts is set to 1 or greater, remote access is enabled. If the
number of unsuccessful login attempts exceeds the limit set by
S41, the modem returns online and any further login attempts
during the remainder of that connection are refused.
Disabling Password Security
If you want to disable an assigned password (and thereby dis-
able remote access security), use the following command format.
AT%PO= <Enter>
or
AT%P1 = <Enter>
If, for example, you disable the %PO password, the remote user
does not need to enter a password for view-only access.
LED Indicator for Remote Access
The Courier's SYN LED flashes to indicate when it is in a remote
access session.
At the Other Modem Site
Remote configuration can be performed at any time during an
asynchronous connection. The user performing remote configu-
ration can use any modem; it does not have to be a USRobotics
model.
E-8 Fax and Other Operations
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-