US Robotics COURIER - Page 184

-
-
8.
-
-
I ,_
-
-
COURIER HIGH SPEED MODEMS
When the modem sends the OK result, reset the modem to
Data mode with the following command.
ATS16=0
The modem signals the responding modem that RDL testing
is over.
Terminate the call as you normally would, and reset
the modem to its normal error control setting, &M4 or &M5.
Or, if you wish to resume data transmission with the remote
modem, add the 0 command to the ATS16=0 string to return
the modem online. Keep in mind, however, that error
control is disabled. Because error control is negotiated
during the connection sequence, its status cannot be changed
until the modem is back on hook and in Command mode.
Modem Testing F-11