K2 K3
K2
K3
M1
Motor 1 control from relay Motor 2 control from relay Motor 3 control from relay
NOT USED
Mains
M2 M3
Fig. 84: Selection 0
SELECTION 1, ENABLED
To include the regulating motor in the autochange or in the interlock logic, obey the
instructions in the figure below. 1 relay controls each motor. The contactor logic always
connects the first motor to the drive, and the next motors to the mains.
VACON · 312 PARAMETER DESCRIPTIONS
10
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
To Next Page
Loading...
