Vacon 100 INDUSTRIAL - Page 130

vacon • 130 Parameters
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
Figure 37. Location of pressure sensor
Figure 38. Input pressure supervision
Table 113. Input pressure supervision parameters
Code Parameter Min Max Unit Default ID Description
P3.13.9.1 Superv. Enable 0 1 0 1685
0 = Disabled
1 = Enabled
Enables the Input Pressure
Supervision.
PT
Mains
Inlet
Outlet
()
Input Pressure
Supervision Fault Level
Input Pressure Alarm
Digital output signal
Supervision Alarm Level
Input Pressure Monitor
PID Setpoint
PID Setpoint
Supervision
Fault Delay
Supervision
Fault Delay
Motor Running
Yes
No
PID Setpoint
Reduction
9213.emf