vacon • 50 User interfaces
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
Figure 16. Typical editing of values on graphical keypad (numerical value)
Parameters with checkbox selection
Some parameters allow selecting several values. Make a check box selection at each value you wish
to activate as instructed below.
Figure 17. Applying the checkbox value selection on graphical keypad
Resetting fault
Instructions for how to reset a fault can be found in chapter 8 .
Function button
The FUNCT button is used for four functions:
1. to quickly access the Control page,
2. to easily change between the Local (Keypad) and Remote control places,
3. to change the rotation direction and
4. to quickly edit a parameter value.
Control places
The
control place is the source of control where the drive can be started and stopped. Every control
place has its own parameter for selecting the frequency reference source. The
Local control place
is always the keypad. The
Remote control place is determined by parameter P3.2.1 (I/O or Field-
bus). The selected control place can be seen on the status bar of the keypad.
9256.emf
...
OK
Symbol for checkbox selection
To Next Page
Loading...
