Parameters vacon • 99
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
7.1.4.2 Group 3.3.3: Preset Freqs
P3.3.1.8 Keypad Reference 0.00 P3.3.1.2 Hz 0.00 184
The frequency reference can be
adjusted on the keypad with this
parameter.
P3.3.1.9 Keypad Direction 0 1 0 123
Motor rotation when control place
is keypad
0 = Forward
1 = Reverse
P3.3.1.10 Fieldbus Ref Sel 1 9 3 122
Selection of ref source when con-
trol place is Fieldbus:
1 = Preset Frequency 0
2 = Keypad reference
3 = Fieldbus
4 = AI1
5 = AI2
6 = AI1+AI2
7 = PID reference
8 = Motor potentiometer
9 = Max Power
P3.3.1.11 Adapt To AC Volt. No Yes No 1931
Parameter enables the possible
limitation on maximum output fre-
quency when connected to AC
mains (digital input from P3.5.1.53
is active), in case the available
voltage is not sufficient to reach
the motor nominal U/f ratio (from
P3.1.1.1 and P3.1.1.2).
The function can be useful if the
motor has been chosen depending
on high DC voltage from solar
modules, but this voltage is not
reachable with AC supply.
Table 66. Preset frequencies parameters
Code Parameter Min Max Unit Default ID Description
P3.3.3.1 PresetFreqMode 0 1 0 182
0 = Binary coded
1 = Number of inputs. Preset fre-
quency is selected according to how
many of preset speed digital inputs
are active
P3.3.3.2 Preset Freq 0 P3.3.1.1 P3.3.1.2 Hz 5.00 180
Basic preset frequency 0 when
selected by Control reference
parameter (P3.3.1.5).
P3.3.3.3 Preset Freq 1 P3.3.1.1 P3.3.1.2 Hz 10.00 105
Select with digital input:
Preset frequency selection 0
(P3.3.3.10)
P3.3.3.4 Preset Freq 2 P3.3.1.1 P3.3.1.2 Hz 15.00 106
Select with digital input:
Preset frequency selection 1
(P3.3.3.11)
P3.3.3.5 Preset Freq 3 P3.3.1.1 P3.3.1.2 Hz 20.00 126
Select with digital inputs: Preset fre-
quency selection 0 & 1
P3.3.3.6 Preset Freq 4 P3.3.1.1 P3.3.1.2 Hz 25.00 127
Select with digital input:
Preset frequency selection 2
(P3.3.3.12)
Table 65. Frequency reference parameters
Code Parameter Min Max Unit Default ID Description
To Next Page
Loading...
