control panel vacon
•
67
7
In edit mode, Left and Right buttons are used to select the digit which has to be
changed, and Up increases / Down decreases parameter value.
In edit mode, the value of Px.x is displayed blinkingly in the panel. After about 10 s,
Px.x is displayed in the panel again if you don't press any button.
Note! In edit mode, if you edit the value and don't press OK button, the
value isn't changed successfully.
In edit mode, if you don't edit the value, you can press Reset /
Back button to display Px.x again.
To Next Page
Loading...
