Vacon 20 - 7.4 Navigation on the Vacon 20 control panel; 7.4.1 Main menu

60
•
vacon control panel
7
7.4 Navigation on the Vacon 20 control panel
This chapter provides you with information on navigating the menus on Vacon 20 and
editing the values of the parameters.
7.4.1 Main menu
The menu structure of Vacon 20 control software consists of a main menu and sev-
eral submenus. Navigation in the main menu is shown below:
Figure 7.2: The main menu of Vacon 20
FWD R EV I/O K EYPAD BUS
REF
MON
PA R
SYS SYS
SYS SYS
SYS SYS
SYS SYS
FAULTALARMSTOPREADY RUN
FW D REV I/O KEY PAD BU S
REF
PA R
FAULTALARMSTOPREADY RUN
MON
FW D REV I/O KEYPAD BUS
REF
PAR
FAULTALARMSTO PREADY RUN
MON
FWD REV I/O KEYPAD BUS
REF
PAR
FAULTALARMSTOPREADY RUN
MON
FWD REV I/O KEYPAD BUS
REF
PAR
FAULTALARMSTOPREADY RUN
MON
FWD REV I/O KEYPAD BUS
REF
PAR
FAULTALARMSTOPREADY RUN
MON
FWD REV I/O KEYPAD BUS
REF
PAR
FAU LTALARMSTO PREADY RUN
MON
PRES S
PRES S
PRES S
PRES S
PRESS
FWD REV I/O KEYPAD BUS
REF
MON
PA R
FAULTALARMSTOPREADY R UN
PRESS
PRESS
OK
OK
OK
OK
OK
In this menu
you can
browse the
monitoring
values.
In this menu
you can
browse and
edit the
parameters.
Dispalys the
keypad reference
value
regardless of
the selected
contron place.
Here you will be
able to browse
system parameter
and fault
submenu.
MONITORING
MENU
REFERENCE
MENU
PARAMETER
MENU
SYSTEM
MENU
Hz
Hz