Vacon 20 - 7.4.4 Parameter menu

66
•
vacon control panel
7
7.4.4 Parameter menu
In Parameter menu only the Quick setup parameter list is shown as default. By giving
the value 0 to the parameter 17.2, it is possible to open other advanced parameter
groups. The parameter lists and descriptions can be found in chapters 8 and 9.
The following figure shows the parameter menu view:
Figure 7.5: Parameter menu
The parameter can be changed as the Figure 7.5.
Left / Right button is available inside Parameter menu. Pressing Left / Right button
to change the actual parameter to the first parameter of the next group (Example:
any parameter of P1… is displayed -> RIGHT button -> P2.1 is displayed -> RIGHT but-
ton -> P3.1 is displayed …). After entering the desired group, pressing UP / DOWN
button to select root parameter number, and then press OK button to display the val-
ue of the parameter and also enter edit mode.
OK
OK
2
Press Right to browse
otherPar. group
4
Press OK button to enter
edit mode
3
Press down button to
browse P3.4
5
Press Up / Down to change value
OK
6
Press OK to confirm
FAULTALARMSTOPREADY RUN
REF
MON
PA R
SYS
REF
MON
PA R
SYS
REF
MON
PA R
SYS
FAULTALARMSTOPREADY RUN
FA ULTALARMSTOPREADY RUN
FWD R EV I/O KEYPAD BUS FWD R EV I/O KEYPAD BUS
FWD R EV I/O K EYPAD BUS
1 Press OK to enter Pa r. menu
FAULTALARMSTOPREADY RUN
REF
MON
PA R
SYS
FWD R EV I/O KEYPAD BUS
FAULTALARMSTOPREADY RUN
REF
MON
PA R
SYS
FWD R EV I/O KEYPAD BUS
Hz