Setting System Time and Time Zone
NETWORKING PAGE
Allowing the switcher to contact a network time protocol (NTP) server ensures that its system time is
correct, and makes the time zone editable. You also have the option to specify which NTP server to use.
1. Enable Automatic NTP Updating.
2. Select the desired time zone from the list.
3. If desired, specify the NTP server to use. If you are not sure about this, use the default.
4. Save your changes.
5. To update the system time immediately, select Refresh. Otherwise, the time will update the next time
the controller contacts the NTP server.
13
Integrator's Complete Guide to the PCC MatrixMIX Live Production Controller
To Next Page
Loading...
