Operating the Controller
The PCC MatrixMIX live production controller is the preferred operator interface for the AV Bridge
MatrixMIX multipurpose AV switcher. We recommend using it with the TeleTouch 27 USB multiviewer if it
is sited with the switcher.
This chapter covers operation of the controller console. Some of these tasks can also be done in other
ways – from the TeleTouch 27 USB multiviewer, or from the switcher's web interface.
To select a touch-panel control, do one of these things:
n Tap the control on the touch-panel
n Dial to the control using the Menu knob, then press the knob to select the control.
You can change some adjustments, such as audio volume sliders, directly on the touch-panel. To adjust
controls that use arcs, such as the touch-panel brightness adjustment, you must use the Menu knob to
make the adjustment, and then press the knob to save the change.
Before You Start
You will need additional information and software to control the cameras, other video sources, and audio
equipment on your network.
n The PCC MatrixMIX can control up to 10 switchers, which must be added to the controller's directory
via the web interface; the admin login is required.
n You will need to view the switcher's multiview output. If you are not using a TeleTouch 27 USB
multiviewer (for example, if operating the switcher remotely), you will need to view the multiviewer
output as an IP stream.
n To view the IP stream, the switcher must be configured to enable IP streaming.
n To view the IP stream, you will need a stream viewer application such as VLC Media Player.
n You will need to know the streaming URL for each switcher's IP stream. This information is available on
the Streaming page of each switcher's web interface; the admin login is required.
n When viewing the multiviewer stream, keep in mind that the stream will lag perceptibly – there is
network-dependent latency in addition to 400 ms of inherent latency.
21
Integrator's Complete Guide to the PCC MatrixMIX Live Production Controller
To Next Page
Loading...
