3. Installation
3.1 Opening and Mounting
To avoid damaging the connector pins of the transmitter, pull the
transmitter cover
o the base in a straight angle. Do not twist or bend.
CAUTION!
1. Loosen the 4 screws on the transmitter cover.
2. Carefully open the transmitter cover part of the way from both sides so it is easier to
pull the cover
o the base.
3. Pull the transmitter cover
o the base in a straight angle. Do not twist or bend.
4. Place the transmitter base on the installation surface and mount it with 3 screws. See
the screw positions in Figure 10 (page 18).
5. Lead the input/output cable inside the transmitter (see Wiring Options (page 19)). If
you are wiring through the lead-through on the bottom of the transmitter, test that the
strain relief works with your cable.
6. Connect the input/output cable's wiring to the screw terminals (see Indigo Transmitter
Base (page 18)) and reattach the cover when done.
Chapter 3 – Installation
17
To Next Page
Loading...
