Vaisala Indigo 201 - Attaching Probes and Cables; Figure 10 Attaching Probes and Cables to Indigo

2.7 Receiving Analog Output Settings
from Probe
When you take Indigo 201 in use for the first time and have not entered an analog output
configuration, the transmitter automatically adapts the analog output configuration of the
first Vaisala Indigo-compatible probe you connect.
If an analog output
configuration already exists in Indigo 201 (that is, you have previously
connected a probe or configured the settings), you need to set the analog output
configuration of the new probe manually. Analog output from the transmitter is halted and
does not resume until you have set the new probe's configuration.
Alternatively, you can clear the analog output settings in Indigo 201 configuration. This
returns the transmitter to a state where it automatically starts using the analog output
configuration of the next connected probe. The analog output settings can be cleared from
the Settings > General menu.
Figure 9 Clearing Analog Output Settings
More Information
‣
Attaching Probes and Cables (page 20)
‣
Analog Output Configuration Overview (page 45)
‣
Clearing Analog Output Settings from Indigo (page 47)
Indigo 201 User Guide M211877EN-E
16