Vaisala Indigo 202 - Probe and Cable Attachment

3.4 Attaching Probes and Cables
1
2
3
Figure 10 Attaching Probes and Cables to Indigo
1 Insert probes into the probe connector with the orientation mark facing out.
2 Probes are locked in place with the locking wheel. Ne
ver turn from the probe body.
3 Connect probe cables in the same way as probes: insert the cable in the connector and
hold in place while turning the locking wheel.
1. Insert the probe into the probe connector with the orientation mark on the probe body
f
acing out.
2. Hold the probe in the probe connector and lock it in place by turning the locking wheel
counterclockwise. Do not turn the probe body when attaching, only the locking wheel
on the transmitter.
3. When the transmitter recognizes the connected probe, it shows a notification message
on the displa
y (for example, Probe Connected: GMP251).
Indigo 202 User Guide M211966EN-A
16