3.3.1 Editing measurement view
You can add, edit, and delete the measurement views in Indigo80. Press while in the
measurement view to open the shortcut menu for editing the views.
Figure 6 Shortcut menu for editing measurement views
1 Two types of templates are available for new views (for examples of dierent types of
measurement views, see Figure 4 (page 17)):
• Default: allows you to add a maximum of 11 new vertically-stacked views. The total
number of views in the stack is 12. Each view fits a maximum of four measurement
parameters.
• Comparison: allows you to add a maximum of 10 new vertically-stacked views. The
comparison template is available only when two probes are connected to
Indigo80.
2 Edit view: you can add new parameters into an existing view (space allowing), or delete
parameters from a view.
3 Delete view deletes the active measurement view or comparison view, as well as the
related graph views.
4 Restore default views deletes all created custom views and restores the default views,
which vary depending on the type and number of probes connected to Indigo80.
The number of new views that can be added is higher for probes with just one output
parameter, for example, GMP252. For multiparameter probes, such as HMP7, the parameter list
views at the bottom of the stack reserve up to three views of the total, allowing for fewer new
views to be added.
More information
‣
Graph view (page 21)
3.3.2 Holding values in measurement view
With the Hold values function you can freeze the measurement view, for example, for taking a
photo of the readings. Date and time are shown on the bottom of the display.
Indigo80 User Guide M212722EN-B
18
To Next Page
Loading...
