1. Unzip the firmware update package ('Indigo80-<version>-firmware.zip') into any folder
on your computer.
The package contains the firmware file and other relevant resource files.
2. Connect a USB cable to a free USB port on your computer.
3. Connect the other end of the cable to the USB-C connector located on the bottom of
Indigo80.
4. Switch Indigo80 on by pressing (if not powered on already).
5. Copy all content from the unzipped firmware package into folder INDIGO80 (serial
number) > Device > Update in your computer's file manager.
6. Firmware transfer starts. The notifications Transferring firmware... > Updating
firmware... > Processing update... > Firmware updated are shown on the Indigo80
display.
After successful update, the notification Firmware updated successfully is shown.
More information
‣
Troubleshooting (page 44)
7.2
Restoring factory default settings
You can restore all Indigo80 settings back to factory defaults. Restoring the settings will not
aect the settings of devices connected to Indigo80.
A factory reset deletes all current settings of the device. After the
factory reset, you need to reconfigure the settings.
CAUTION!
1. In the Indigo80 main menu, select Indigo80 > Factory default settings.
2. If you wish to remove all data files stored in Indigo80 in addition to resetting the device,
highlight the Also delete data files check box and press the
button to select the
option. To deselect the option, press again.
3. Select Restore > OK. The device restarts.
Indigo80 User Guide M212722EN-B
42
To Next Page
Loading...
