Vaisala Indigo80 - Recharging Indigo80 Battery; Removing Battery

Symbol on display Description
Charge level percentage and red battery symbol shown when the battery
level is below 5 %.
A full-screen notification Battery level below 5 % is displayed.
The Indigo80 status LED will blink red to indicate that the battery needs
recharging.
Charge level percentage and yellow lightning symbol shown when the
indicator is connected to a power supply and the battery is charging.
6.1.2 Recharging Indigo80 battery
Note the charging temperature of the battery, 0 … +45 °C (+32 …+113 °F).
1. Connect the USB-C connector of an AC adapter to Indigo80.
The USB-C port is located on the bottom of Indigo80.
2. Plug in the AC adapter to a wall socket.
A yellow lightning symbol in the lower right corner of the display indicates that the
battery is charging. When the display is o, charging status is indicated by a green LED in
the keypad. Typical recharge duration from empty to full battery with a 45 W adapter is
approximately 2 h.
6.1.3 Removing battery
If you need to replace the M4×14 hex screws on the back cover of
Indigo80 with new ones, make sure the replacing screws are identical to the
original ones: exactly 14 mm (0.55 in) in length. Screws that are shorter or longer
than 14 mm (0.55 in) may damage the device or compromise its ingress
protection.
CAUTION!
• 2-mm Allen key for the M4×14 hex screws on the back cover of Indigo80
1. Detach any USB or probe connection cables from Indigo80.
2. Turn o Indigo80 by pressing the power button for 2 seconds.
3. Place the indicator on a clean, flat surface, with the display facing down.
4. Open the screws (2 pcs) on the back cover and lift the cover to remove it.
Indigo80 User Guide M212722EN-B
38