1. While in the measurement view, press to open the shortcut menu.
2. Select Hold values.
The measurement view freezes and the altered state is indicated by a yellow frame and
the text hold in the bottom right corner of the display.
3. Exit the view by pressing or .
3.3.3 Setting measurement limit alarm
You can set a one-time measurement limit alarm for any one parameter output by your probe.
When the measured value exceeds or falls below the set limit, this triggers a visual and audible
alarm.
1)
Note that you can set the alarm for one parameter from one probe at a time.
1. While in the measurement view, press to open the shortcut menu.
2. Select Set alarm > Parameter.
1) Turn sounds on in Indigo80 settings to activate the audible alarm.
Chapter 3 – Indigo80 menus and views
19
To Next Page
Loading...
