If you need to replace the M4×14 hex screws on the back cover of
Indigo80 with new ones, make sure the replacing screws are identical to the
original ones: exactly 14 mm (0.55 in) in length. Screws that are shorter or longer
than 14 mm (0.55 in) may damage the device or compromise its ingress
protection.
CAUTION!
A magnetic hanger is available as an optional accessory for attaching Indigo80 to metallic
surfaces while taking measurements. Vaisala item code of the hanger is ASM214318SP.
• 2-mm Allen key for the M4×14 hex screws on the back cover of Indigo80
1. Detach any USB or probe connection cables from Indigo80.
2. Turn o Indigo80 by pressing the power button for 2 seconds.
3. Place the indicator on a clean, flat surface, with the display facing down.
4. Remove the topmost screw from the back cover and place it aside.
5. Position the screw hole of the magnetic hanger on Indigo80, with the text VAISALA on
the hanger facing out.
6. Keep the hanger positioned in line with Indigo80 and tighten the screw to fasten the
hanger into place.
More information
‣
Spare parts and accessories (page 50)
7.5
Troubleshooting
If you have a problem with using Indigo80, check the following tables before contacting
Vaisala. If the problem you have is not listed in the tables, or if the proposed solution does not
fix the problem, contact Vaisala. See Technical support (page 52) for more information.
Indigo80 User Guide M212722EN-B
44
To Next Page
Loading...
