Valor H6 - Page 77

77
Appendix B - Remote Control Operation
Error Codes
In the event of an error condition with the handset or ȴ replace, the handset will display an error code.
Failure
Code
Message on
Handset
Duration of
Display
Symptom Possible Cause
F04 F04 4 sec
• No pilot ȵ ame within 30 sec
• Note: after 3 failed ignition
sequences, F06 shown
• No gas supply
• Air in pilot supply line
• No spark
• Reversed polarity in thermocouple wiring
F06 F06 4 sec
• 3 failed ignition sequences
in 5 minutes
• Fire is not responding, no
pilot ȵ ame
• No gas supply
• Air in pilot supply line
• No spark
• Reversed polarity in thermocouple wiring
• Incorrect pilot oriȴ ce if valve has been
converted from LPG to NG or vice versa
F07 Low battery
symbol
Permanent
• Battery icon ȵ ashes on
handset display
• Low battery in handset
F09 F09 4 sec
• Fire is not responding
• No electronic control of ȴ re
• Down arrow button
was not pressed during
pairing
• Receiver and handset are not synced
F46 F46 4 sec
• Fire is not responding
• Intermittent response
• No electronic control of ȴ re
• No or bad connection between receiver and
handset
• No power at receiver (batteries low)
• Low communication range (mains adapter
faulty, handset not communicating with
receiver)