54
Fuel BedsInstallation
Driftwood 1400DWKV2
Material required
• Driftwood kit, which contains:
• 7 logs
• 4-piece ceramic plaque
• 7 pebbles
• Gloves, if desired (not supplied)
Installation
Carefully unpack the kit. Identify each log according to
the above image.
Ceramic Plaque
1. Place the front left ceramic piece of the plaque on
the burner cover.
2. Place the front right ceramic piece.
3. Place the rear right ceramic piece.
4. Place the rear left ceramic piece.
Logs
Please note that the position of the logs is critical to
ensure the proper performance of the appliance.
1. Place ember bed H37 onto the burner. Carefully
locate it centered left to right and front to back.
Ceramic plaque installed
H37
H63
H37
H62 H64
H65
H61
H60
To Next Page
Loading...
