VAMP 257 - Setting Range Limits and Fault Messages

VAMP 257 Feeder and motor manager
Operation and configuration
VAMP Ltd
28
VAMP 24h support phone +358 (0)20 753 3264 VM257.EN002
4.6. Setting range limits
If the given parameter setting values are out-of-range values, a
fault message will be shown when the setting is confirmed with
the ENTER key. Adjust the setting to be within the allowed
range.
Figure 4.6-1. Example of a fault message
The allowed setting range is shown in the display in the setting
mode. To view the range, push the INFO key. Push the
CANCEL key to return to the setting mode.
Figure 4.6-2. Allowed setting ranges show in the display
4.7. Adjusting display contrast
The readability of the LCD varies with the brightness and the
temperature of the environment. The contrast of the display
can be adjusted via the PC user interface, see chapter 6 on page
39.