VAMP 257 - Configuring Digital Inputs (DI) and Outputs (DO); Prot Menu Configuration

VAMP 257 Feeder and motor manager
Operation and configuration
VAMP Ltd
32
VAMP 24h support phone +358 (0)20 753 3264 VM257.EN002
5.3. Configuring digital inputs DI
The following functions can be read and set via the submenus
of the digital inputs menu:
• The status of digital inputs (DIGITAL INPUTS 1-32)
• Operation counters (DI COUNTERS)
• Operation delay (DELAYs for DigI
n
)
• The polarity of the input signal (INPUT POLARITY). Either
normally open (NO) or normally closed (NC) circuit.
• Event enabling EVENT MASK1
5.4. Configuring digital outputs DO
The following functions can be read and set via the submenus
of the digital outputs menu:
• The status of the output relays (RELAY OUTPUTS 1,2 and
3)
• The forcing of the output relays (RELAY OUTPUTS 1, 2
and 3) (only if Force = ON):
• Forced control (0 or 1) of the Trip relays
• Forced control (0 or 1) of the Alarm relays
• Forced control (0 or 1) of the IF relay
• The configuration of the output signals to the output relays.
The configuration of the operation indicators (LED) Alarm
and Trip and application specific alarm leds A, B and C
(that is, the output relay matrix).
5.5. Configuration of Prot menu
The following functions can be read and set via the submenus
of the Prot menu:
• Reset all the counters (PROTECTION SET/ClAll)
• Read the status of all the protection functions (PROTECT
STATUS 1-x)
• Enable and disable protection functions (ENABLED
STAGES 1-x)
• Define the interlockings between signals (only with
VAMPSET).
Each stage of the protection functions can be disabled or
enabled individually in the Prot menu. When a stage is
enabled, it will be in operation immediately without a need to
reset the manager.