VAMP 257 - Single Line Diagram Editing

VAMP Ltd Feeder and motor manager
Operation and configuration
VAMP 257
VM257.EN002 VAMP 24h support phone +358 (0)20 753 3264
37
ProfiBus DP
• ProfiBus profile (Mode)
• The transfer rate of the converter (bit/s)
• Event mode
• ProfiBus Tx Buf length (InBuf)
• ProfiBus Rx Buf length (OutBuf)
DNP 3.0
• Transfer rate (bit/s)
• Parity
• Slave address (SlvAddr)
• Master address (MstrAddr)
• Link layer confirmation timeout (LLTout)
• Link layer retry counter (LLRetry)
• Application layer confirmation timeout (APLTout)
• Application layer confirmation mode
• Double-Bit input support (DBISup)
• Clock sync mode
TCP/IP
•
The IP address of the manager (Ip)
• Subnet mask (N)
• The IP address of the Gateway (Gatew)
• The IP address of the Name Server (NameSv)
• The IP address of the SNTP Server (NTPSvr)
• The port number used in remote protocol (e.g.
ModBusTCP) communication (Port)
5.9. Single line diagram editing
The single-line diagram is drawn with the VAMPSET software.
For more information, please refer to the VAMPSET manual
(VMV.EN0xx).