Vanair 050817 - Compressed Air Can Cause Injury; Trapped Air Pressure and Whipping Hoses Can Cause Injury; Hot Metal from Air Arc Cutting and Gouging Can Cause Fire or Explosion; Hot Parts Can Cause Severe Burns

AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 1: SAFETY
090019-OP_r0 Page - 13
1.6.3 COMPRESSED AIR CAN CAUSE INJURY
Wear approved safety goggles.
Do not direct air stream toward self or
others.
1.6.4 TRAPPED AIR PRESSURE AND WHIPPING
HOSES CAN CAUSE INJURY
Release air pressure from tools and
system before servicing, adding or
changing attachments, or opening
compressor oil drain or oil fill cap.
1.6.5 HOT METAL FROM AIR ARC CUTTING AND
GOUGING CAN CAUSE FIRE OR
EXPLOSION
Do not cut or gouge near flammables.
Watch for fire; keep extinguisher nearby.
1.6.6 HOT PARTS CAN CAUSE SEVERE BURNS
Do not touch hot parts bare handed.
Allow cooling period before working on
equipment.
1.6.7 READ INSTRUCTIONS
Read Owner’s Manual before using or
servicing unit.
Stop engine and release air pressure
before servicing.
Use only genuine Air-N-Arc replacement
parts.