AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 1: SAFETY
090019-OP_r0 Page - 19
precaution and awareness of hazardous conditions.
Always heed the information noted on the safety decals.
1.12 DISPOSING OF MACHINE
FLUIDS
Always dispose of machine fluids under
the guidance of all applicable local,
regional and/or federal law.
Vanair encourages recycling when
allowed. For additional information,
consult the container for information.
For further information on machine fluid maintenance,
consult the following:
WARNING
DO NOT REMOVE OR COVER ANY
SAFETY LABEL. Replace any safety label
that becomes damaged or illegible.
WARNING
If applicable: For machine packages that
contain labels to be affixed after machine
arrival, all safety decals MUST be placed
on machine, in their appropriate
positions respectively, as shown in the
Decal Section (Section 9.11) of this
manual.
MAINTENANCE TASK SECTION LOCATION / FIGURE
ENGINE OIL
I
:
6.5.9.2, Checking the Engine Oil
6.5.9.3, Replacing the Engine Oil
Figure 6-21
COMPRESSOR OIL: 6.5.2 Compressor Oil Maintenance
Figure 6-2 (drain plug location)
I
In addition to the sections, also consult the Engine Opera-
tor’s Manual when performing maintenance.
To Next Page
Loading...
