SECTION 6: MAINTENANCE AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 64 090019-OP_r0
7. With the new air filter assembly in place within
the body, position the body below its seating
on the compressor unit. NOTE: Compressor-
side of body [F] faces in toward the
compressor unit.
8. Swing the upper edge of spring clamp [C] so
that its end fits into the groove on the
compressor.
9. Push down on the lower end tab of the spring
clamp to lock the spring clamp into place.
10. Repeat Steps #8 and #9 for the clamp on the
other side of the air filter body to secure the
filter into place.
KEY DESCRIPTION KEY DESCRIPTION
A COMPRESSOR UNIT C
3
Release upper edge of spring clamp
B COMPRESSOR AIR FILTER D
AIR FILTER ASSEMBLY
I
C RELEASING AIR FILTER BODY E AIR FILTER BODY
C
1
Grasp body at base for support F COMPRESSOR-SIDE OF BODY (faces
compressor)
C
2
Lift lower edge of spring clamp
I
Order Air Filter Assembly Replacement Kit no. RC99245.
Figure 6-1: Air Inlet Filter Replacement Kit
To Next Page
Loading...
