VAT 653 Series - Page 36

129 pages

To Next Page

To Previous Page

INSTALLATION Series

36/129

Edition 2019-05-03 963283EA

4.3.3.4 Interface Connector: Configuration with voltage source for digital inputs

Main Page

Table of Contents3
Description of Product6
Identification of Product6
Use of Product6
Used Abbreviations6
Related Documents6
Important Information6
Technical Data7
Control and Actuating Unit7
Valve Unit10
Safety12
Compulsory Reading Material12
Danger Levels12
Personnel Qualifications13
Safety Labels13
Design and Function14
Design14
Function15
Pressure Control System Overview and Function16
Principle of a Pressure Control System17
Installation18
Unpacking18
Installation into the System19
Installation Space Condition20
Connection Overview21
Installation Procedure22
Tightening Torque23
Mounting with Centering Rings23
Mounting with O-Ring in Grooves24
Admissible Forces25
Requirements to Sensor Connection25
Electrical Connection26
Ground Connection27
Power and Sensor Supply Concepts28
Digital Input/Output and Analogue Output Connections34
RS232 Interface Connection39
Service Port Connection39
Initial Operation40
Scaling of Pressure and Position Values41
Valve Configuration42
Homing Start Option42
Power Failure Option42
Digital I/O43
RS232 Interface Configuration44
Sensor Configuration44
Zero Adjust47
Learn (Adaptive Control Algorithm)49
Pressure Control51
Pressure Control Operation with 2 Sensors52
Control Parameters53
Choose Correct Control Algorithm57
Tuning of Control Performance58
RS232 Interface Commands (IC Protocol)68
RS232 Command Syntax68
Control Commands68
Inquiry Commands69
Setup Commands74
Pressure Control Algorithem84
Error Messages89
RS232 Interface - Commands (PM-V2 Protocol)90
Control Commands (PM-V2 Compatible)90
Inquiry Commands (PM-V2 Compatible)91
Setup Command (PM-V2 Compatible)93
Sensor Delay Command (PM-V2 Compatible)94
Error Messages (PM-V2 Compatible)94
Operation95
Normal Operation95
Remote Operation95
Local Operation96
Close Valve97
Open Valve97
Position Control97
Pressure Control97
Display Information98
Power up98
Operation99
Error99
Safety Mode99
Operation During Power up100
Behavior in Case of Power Failure100
Operation under Increased Temperature101
Behavior in Case of Compressed Air Pressure Drop101
Trouble Shooting102
Controller Display102
Error Numbers102
Error Code102
Maintenance104
Maintenance Intervals104
Maintenance Procedures105
7.2.1 Replacement of Isolation Seals and Valve Cleaning106
7.2.2 Replacement of Actuator Shaft Seals109
Replacement of Option Board114
Retrofit / Replacement Procedure116
Repairs118
Dismounting and Storage119
Dismounting119
Storage120
Packaging and Transport121
Packaging121
Transport122
Disposal123
Spare Parts124
Drawing124
Valve Unit with Seals and Grease125
Control and Actuating Unit126
Accessories127
Appendix128

VAT 653 Series - Page 36

Table of Contents

Related product manuals