Vatech PaX-i3D Smart - General Safety Guidelines for Operation

Pax-i3D Smart(PHT-30LFO) Installation Manual
13
Table of Contents
TABLE OF CONTENTS
1
Introduction ........................................................................................ 15
1.1 Manufacturer’s Liability ....................................................................................................16
1.2 Customer’s Responsibility ...............................................................................................16
1.3 Marks & Symbols .............................................................................................................17
1.4 Standards and Regulations ............................................................................................18
2
Choosing an Installation Site ............................................................ 19
2.1 Room Requirements .......................................................................................................20
2.2 Specications for Electrical Installation ..........................................................................23
2.3 Electrical Requirements ..................................................................................................23
2.4 Temperature and Humidity ..............................................................................................25
2.5 Exposure Switch Installation Options ..............................................................................25
2.6 Installation Versions .........................................................................................................27
2.7 Installing the Warning Lamp and Door Interlock Switch ..................................................28
2.8 Installing the Emergency Stop Switch .............................................................................28
3
Before Installing the System ............................................................. 29
3.1 Required Tools .................................................................................................................30
3.2 Checking the ShockWatch and TiltWatch Indicators .......................................................32
3.3 Unpacking the Boxes .......................................................................................................33
3.4 Checking the Parts ..........................................................................................................41
4
Installing the Equipment: Floor Standing (Optional) ...................... 47
4.1 Assembling the Base and Main Units ..............................................................................48
4.2 Installing the CEPH Unit (Optional) .................................................................................51
4.3 Connecting the Cables to the Equipment ........................................................................54
4.4 Installing the Wall and Column Brackets .........................................................................55
4.5 Fixing the base (Optional) ...............................................................................................59
4.6 Removing the Transportation Safety Bolts ......................................................................62
4.7 Leveling the Equipment ...................................................................................................64
4.8 Tightening the Bolts rmly ..............................................................................................66
5
Completing Miscellaneous Works .................................................... 67
5.1 Assembling Various Covers .............................................................................................68
5.2 Assembling Temple and Chin Supports ...........................................................................70
5.3 Installing the Switch Holders ...........................................................................................71