Pax-i3D Smart(PHT-30LFO) Installation Manual
30
3 Before Installing the System
3.1
Required Tools
The following tools are necessary to install the
PaX-i3D Smart.
Item Figure Size
Wrench set
Allen wrench set
1.5mm-10mm
(0.05"-0.4")
1.5 mm-10 mm/0.06”-0.4”
T-shaped hex wrench 6 mm-10 mm/0.24”-0.4”
Hex wrench w/ handle 6 mm-10 mm/0.24”-0.4”
Ratchet wrench Tips: 3 mm-8 mm/0.12”-0.3”
Needle-nose pliers regular
Monkey wrench
Cross head screw driver
w/ magnetic tip
L=200 mm(7.9”)
Spirit level
To Next Page
Loading...
