Pax-i3D Smart(PHT-30LFO) Installation Manual
05
Notice to the Installers
Important Notes
Moisture could be built up on the equipment from a sudden temperature change
inside and outside the installation room. Allow at least an hour before turning
ON the equipment to avoid condensation.
1.
In order to avoid improperly balanced equipment, install the device on a at
surface to maintain stability.
2.
If the equipment is not stable, property damage and/or personal injury may
occur.
3.
Do not push or pull the equipment.
4.
Equipment should only be installed by an authorized technician, complying
with proper installation procedures.
Failure to read and understand the information provided in this manual may
result in physical injury, damage to the equipment or equipment failure. Please
read each CHAPTER in its entirety and understand the information therein
before attempting any of the installation procedures.
To Next Page
Loading...
Need help?
General
