9. Troubleshooting
111
I
PaX-i3D Smart
English
If the laser beam has shut off and patient alignment cannot be
performed
Cause Solution
The time allotted for
patient alignment has
expired
Press the laser beam button to turn on the lasers and
then carry out patient alignment.
If a problem occurs during image acquisition, press the red emergency
stop switch to immediately stop all moving parts and cut off all power to the
equipment’s electrical components. You may then safely release the patient from
the equipment.
Do not allow any liquids in the vicinity of the machine as moisture may cause
extensive damage to this equipment’s electrical components.
To Next Page
Loading...
